Author Topic: almost finished the running in  (Read 819 times)

JOOLZ

  • Full Member
  • ***
  • Posts: 937
almost finished the running in
« on: August 20, 2012, 09:36:08 AM »
I wrote in my last post that my bike had passed its MOT, and wishing the weather would improve, well every weekend since its been fine, and I have been clocking up the miles carefully running it in. Yesterday I thought it would be ok to give it some real throttle, and I am very impressed 3 figures 2 up easily, it even went up hill at tick over in 1st gear. It needs a very light touch on the throttle pulling away as the front wheel becomes airborne even at 2000 rpm. The only thing I dont like about it is the steering, the bike is very light with narrow bars, and the taper roller bearings make it weave at lower speeds and the steering is very heavy, so I will change it back to the standard ball races at some point in the future.

trophydave

  • Posts: 374
  • Dave the rave
Re: almost finished the running in
« Reply #1 on: August 20, 2012, 12:24:06 PM »
Try slackening the taper rollers off just a touch.I have found that if they are a bit too tight bikes can wander about at low speed.

002

  • Posts: 1786
  • Stalwart(TM)
Re: almost finished the running in
« Reply #2 on: August 20, 2012, 10:43:30 PM »
Sounds as if headbearings are too tight.

Jethro
Cooey
Martini-Greener GP
Lee Enfield
ELG

JOOLZ

  • Full Member
  • ***
  • Posts: 937
Re: almost finished the running in
« Reply #3 on: August 21, 2012, 06:02:49 PM »
Try slackening the taper rollers off just a touch.I have found that if they are a bit too tight bikes can wander about at low speed.
I tried that today, it lessened the weave a little but the steering is still too heavy.