« previous next »
Pages: [1]

Author Topic: 6 versus 12  (Read 430 times)

Ian

  • Full Member
  • ***
  • Posts: 2008
6 versus 12
« on: April 26, 2019, 11:37:46 PM »
No nothing to do with batteries.....
Just wanted opinions on 6 point versus 12 point sockets.
Any thoughts, feelings or experiences?
Ian
« Last Edit: April 27, 2019, 03:45:07 PM by Ian »
Logged
1 New SRX 1 C400X 1 GB350S

iansoady

  • Full Member
  • ***
  • Posts: 1902
Re: 6 versus 12
« Reply #1 on: April 27, 2019, 01:44:51 PM »
6 point grip better but can be awkward to position. 12 point easy to get on but unless a good fit can damage the hexagon.

Flank drive? https://www.snapon.com/Industrial-Certification/Aviation-Tools/Hand-Tools/Flank-Drive-Sockets

They're supposed to be the best but by the time I found out I was fully kitted out......
Logged
Ian.
1964 Norton Electra
1969 BSA-Suzuki-Steib S501 (the B'Zuki)
1948 BSA C11

timbo

  • Posts: 2920
Re: 6 versus 12
« Reply #2 on: April 29, 2019, 10:12:58 AM »
I too have been told that flank drive sockets are the dogs danglies, but can't see me buying any anytime soon  :)
Logged
Namaste

BrendanO

  • Posts: 347
  • Procrastinating in Embra
Re: 6 versus 12
« Reply #3 on: April 29, 2019, 10:01:02 PM »
Are they like the AWD Sockets/spanners - all wall drive, ie they grip the middle of each nut face rather than the corners?

Those are great! Had a cheap set of them as combi spanners for >20 years, and bought some single sockets shen things were very stuck (use with impact driver, or breaker bar + scaffold pole.

They also work for metric or imperial sizes...handy if you run a mixed fleet!
Logged
XBR500,  FT500 (USA reg still but now starts/runs nicely!)
non-thumpers CX500EC, NTV650P
Pages: [1]
« previous next »