Honda flywheel puller D

[guest27]

Hi does anyone have the Honda Flywheel Puller D or a pattern part I can borrow - part No 079330010000

Dave Silver does have them - on special order - but will take over a week to get in.

It is for a CG125 but I would guess it fits many of the smaller Hondas.  I may even have one myself - but if I do who knows where it is.  There is no room for a 3-leg puller, this thingy is about 22mm OD thread and a threaded 'bolt' through that.

R

[squirrelciv]

Haven't sorry Rog, but when I needed the flywheel off Abigail I just popped the motor down to the local bike garage and slipped the guy a £5. Job done in under a minute.

[guest146]

If you have access to or know an HGV fitter, the HGV wheel studs that are on 90% of heavy trucks are the same thread. Just wind it in and tap the pulley and off it comes. Fits the Dommi I know that for sure.

Ken

[guest27]

Thanks to both of you

Will liberate a wheel bolt off the next HGV that parks on the zig-zags outside the school... 

R

[KirriePete]

Is it the same one as the C50/70/90 ?  Lefthand thread on the outer IIRC.  If so, I've got one buried in the Shed that currently has no purpose in life and would probably welcome some action.

[guest27]

Not sure if it is the same one - but my guess would be yes.  Any chance of a borrow?

R

[KirriePete]

Not sure if it is the same one - but my guess would be yes.  Any chance of a borrow?

R

I'll have a rummage in the shed tonight, post up a piccy so you can check then PM me with delivery requirements. 

[guest564]

You can quite often use the rear wheel spindle.

[guest27]

Most often to hold the rear wheel in... 

I had thought that as I was pulling the cases off - but the rear spindle is 10mm or 12mm and the hole is 22mm or there abouts but a good thought.

R

[blew]

I have a puller that fits small Hondas-50/70/90 etc..Where are you?

[crackedhead]

lings.com show that item is available, at £6.24, for next day dispatch.

Good luck

[guest27]

I have a puller that fits small Hondas-50/70/90 etc..Where are you?

Hi Blew

I am in Cwmafan / Port Talbot.  Thanks, however Kirriepete is sending me one that is clutter in his shed.

R

[blew]

I'm quite close.If you want it today,ring me on 07761330285

[guest27]

Hi Blew

Thanks - was wall to wall with kids last night - boss in meeting till 9:30ish so did not have a chance to call.  Pete's turned up this am in the post.

Where abouts are you?

R