srx 600 handle bars & carbs

[Steve H]

[nipper32]

alan how much would you want for rearsets do they bolt straight on or do you have to make any mods
                             cheers nipper

[Steve Lake]

If you have a CAD file that would be fine, i have access to Autocad....b ut it would need to be a compatable version I think (although autocad is backward compatable i think)

[srx6]

Hi Nipper
You can have a pair for £25.00 inc postage as long as you are in the UK.The only mod you might have to do is open the holes out.At the moment all three holes are 10mm diameter.

Regards
Alan

[Steve H]

Alan, I'd be interested in a pair as well if its easy to knock out a few sets at the same time.

[nipper32]

hi alan
         yes would like a set of rearsets email me your phone number at
 Lrnipper@aol.com and i,ll give you a phone
                                                             regards nipper

[Steve Lake]

I'm up for a set too m8........if it's not going to be a problem

[srx6]

Hi Gents
I need addresses to send the rearsets to?Steve H whilst im on,i cannot reply to messages from my computer at home,it does not have the toolbar at the bottom of the page but i am sure i am logged in.Any ideas?

Regards
Alan

[Steve H]

Your logged in status should be displayed on the right handside of the title bar (the one with Thumperclub logo).  This should say something to the effect of "You are Logged in as Srx6" or "You are not logged in xx.xx.xx.xx" where xx.xx.xx.xx is your IP Address

[nipper32]

hi alan my address is
 Lindsay Rae
 32 Heronhill Crescent
 Hawick
 Roxburghshire
 TD9 9RS
 
 Give me your address and total cost including posting rear sets
 and i,ll send a cheque down to you
                                               regards nipper

[beeman]

Hi Alan
I'm interested in a set as well, steve D  has my number and address let me know how you want paying. I could collect from your house.

beeman

[nipper32]

i,ve fitted my rearsets just waiting for pegs yo fit on they are the dogs bollocks only needed a little bit of grinding to get by frame welding 10 minute job to fit
you can see them in project pictures TOTAL REBUILD

[srx6]

Looked at the photos and i must say they do look good.If your pegs are like mine that i fitted to my Goose they will have two square dogs on them to stop them from twisting around.An easy way to fit them is to drill the rearsets with the dia that is the size of the width of the dog then with a file round the dogs of to fit.Does that make any sense to you?

Regards
Alan

[nipper32]

yes alan it makes sense my pegs are on order and i.ll see how they fit. did you receive cheque i sent
                                                              regards nipper

[srx6]

Received the cheque,thanks.

Alan