Exhaust headers

[guest1406]

Hi all,

Im on to my exhaust now, headers are done, 2 into one joint is done and can is ready.

I'm in need of steel ring / disk that I can weld to the headers so that the collars, when bolt to the head will pull the whole header air tight. I tried to cut and shape one but it came out bodged, tired to do it a hole saw but they came out way off.

Any suggestions?

Outside diameter measuring 44mm - Inside diameter measuring 33mm

Cheers,

Mackenzie

[themoudie]

Aye Mackenzie,

Try this Ebay 'Lot Number': 360659012053

Probably best to contact first afore placing order. Seems cheap compared with time and effort phaffing. OK, OD maybe a bit big, but short of a BIG press, double edged die etc this is going to be the easiest.

Apologies if it raises false hopes.

Full_Ebay_link

My regards, Bill

[Steve H]

Out of interest how did you make your 2-1 connector ?. Do you have any pictures

[guest1406]

I used this method this guy uses:
http://www.hdforums.com/forum/sportster-models/638096-my-70-2-into-1-exhaust.html

Mine came out like this. A lot smaller of course, i cleaned it up and it looks nicer now

Mackenzie

[deleted to save space]

[Moto63]

Looking good, bit of cleaning up and it,ll look the biz.

[timbo]

I love this idea. I'm sure its not quite as straight forward as it looks, but is anything 

[guest1406]

Bill I just bought a few of those washers and the fit absolutely perfect!!! Once i get some more gas for the welder ill measure them up and do it. Cheers for that!!

Honest timbo if I can do it anyone can!

Mackenzie

[themoudie]

Aye Mackenzie,

That was just a 'light bulb' moment and a poke at Google, "just in case"! 

Pleased to have been of assistance.

My regards, Bill