Thumper Club Forum

Technical => Bike Problems/Questions => Topic started by: guest1376 on October 17, 2011, 08:39:50 AM

Title: XBR Mixture Screw
Post by: guest1376 on October 17, 2011, 08:39:50 AM

Hi, just wondered if anybody could give me some ideas on how to get to this screw to adjust it....?

Thanks in advance....

Title: Re: XBR Mixture Screw
Post by: Nell on October 17, 2011, 06:32:24 PM

I use one of the small flat screwdriver bits that come as part of most cheap universal screwdriver sets.
Add a small piece of plastic tube or a plastic valve cap to the end to give a better grip.
Pull the kickstart out of the way, locate from underneath then twiddle.
Bit of a fiddle but not too difficult.