Thumper Club Forum

Club House => Chatter => Topic started by: guest868 on April 22, 2010, 07:20:07 PM

Title: Lathe help?
Post by: guest868 on April 22, 2010, 07:20:07 PM

Not sure if this is the right place, but I couldn't think of where else to put it? Iam after some spacers and 2 flanges to be made. These spacers and flanges actually-

(http://i97.photobucket.com/albums/l230/phatphord/bikes/spacers.jpg)

Preferred material is 304 stainless, but I could live with it in another material.
Help appreciated, if you want to pm me quotes, then feel free.

Title: Re: Lathe help?
Post by: Ian on April 22, 2010, 07:49:13 PM

Just a few questions. How thick are the flanges? what do you call "another material"? and how urgent are they?

Ian :)

Title: Re: Lathe help?
Post by: guest868 on April 22, 2010, 07:52:28 PM

Ah yes, I did notice I had neglected to add that thickness; 4mm min thickness if from steel, 6mm if alloy.
Materials; all bar the top pair (38mm id) and bottom 6 (8.5mm id) can be anything tough, as they are wheel spacers. The others will need to be at the least steel, as they will be welded. Makes sense?  ???
Urgent? a couple of weeks turnaround?

Title: Re: Lathe help?
Post by: Ian on April 22, 2010, 10:45:24 PM

Flange has now been altered so I can upload onto here

(http://i193.photobucket.com/albums/z24/ian650/Flange.jpg)

Title: Re: Lathe help?
Post by: guest868 on April 23, 2010, 07:58:16 AM

That'd be right. If you can do them, can you give me a quote please? I've had a couple so far.