Thumper Club Forum
Club House => Chatter => Topic started by: Moto63 on April 07, 2021, 07:19:59 AM
-
Nice little suzi flat tracker on pipeburn site if any one would like a look 👀
Cheers, Michael
-
Here is the link Michael.
Suzuki-st250-scrambler (https://www.pipeburn.com/tastefully-done-suzuki-st250-scrambler-by-heiwa-motorcycles/)
A very nice understated bit of kit that I like and would get dirty! ;D
Good health, Bill
-
That's very neat, kind of a cross between a 70's street scrambler and a modern bobber.
-
Yes that’s the one... thanks for the link Bill 👍👍
-
(https://www.pipeburn.com/wp-content/uploads/2021/04/SUZUKI_ST250_hero2-1.jpg)
-
That is nice thanks Michael. I think Hilary would go bananas though if she thought I was about to transform the newly acquired GN.
Spartacus
-
I always enjoyed my old GN. I often thought the GN engine in a trail bike chassis would make a nice little off roader.
-
I put a 21" wheel in one of mine, managed to do a lot of green lane runs with club and on my own, if i had only put a higher exhaust on it would have been better, changed front sprocket and it helped a lot,but would only do 50mph !!! ps...it`s a rumour that I had three black gn`s with the same reg number... :-\
-
That's a beut Rufus, can you remember what the wheel was off? You can see where this is going!
Strange how some bikes have multiple number plates isn't it? I definitely didn't have two ER5s like that!
Spartacus
-
It was a ts125 suzuki wheel, home turned spindle, the biggest problem was a torque arm, not being an engineer i didn`t do a very good job, it worked but had some play,..
-
Tasty looking wee bike. Very understated 8)