« previous next »
Pages: [1]

Author Topic: XBR v GB wiring  (Read 853 times)

mthee

  • Full Member
  • ***
  • Posts: 1887
XBR v GB wiring
« on: December 20, 2019, 11:41:59 AM »
I've been using SteveC#222's GB500 diagram, but was recently given the XBR specific one by Mutt. Thanks to both!
I noticed that the GB starter button is wired to cut the headlight whilst engaging the starter motor, but the XBR isn't.
Anyone know why?
Also, in my electrical infancy, I don't understand why the 2 position dimmer switch is shown with a 3rd position -  (N) ??? The diagram below is for the GB to show the starter wiring. The dimmer wiring is the same for both GB and XBR. Thanks.
« Last Edit: December 20, 2019, 01:16:33 PM by mthee »
Logged
Fear of the unknown does not mean the unknown needs to be feared

mthee

  • Full Member
  • ***
  • Posts: 1887
Re: XBR v GB wiring
« Reply #1 on: December 20, 2019, 11:04:27 PM »
Here's a better diagram, showing the dimmer switch with a 3rd (middle?) position, in which both high and low beams are connected to the battery simultaneously. Eh? I'm sure it's my lack of knowledge  ::)
Logged
Fear of the unknown does not mean the unknown needs to be feared

JOOLZ

  • Full Member
  • ***
  • Posts: 936
Re: XBR v GB wiring
« Reply #2 on: December 25, 2019, 11:36:01 AM »
Dont know about that, strange that the main and dipped at the same time, bet it would light up the road well
Logged
Pages: [1]
« previous next »