« previous next »
Pages: [1]

Author Topic: chain question  (Read 566 times)

spooky

  • Full Member
  • ***
  • Posts: 1069
  • Sunny Dumfries
chain question
« on: February 23, 2019, 02:37:56 PM »
Ok, bike had a 101 link chain, which was fully adjusted and as far forward as possible, correct chain is 102 links and is fine, fitted and whizzing around fine, my question is.... if i fitted a half link to the 101 chain using two connecting links,  how many links would it be ???i have puzzled over it and i think it will be 103 ? (i don`t have a half link yet)
Logged
Gn250,CG125, Terrot 125,st70

Propellor

  • Posts: 1187
Re: chain question
« Reply #1 on: February 23, 2019, 05:07:18 PM »
This might be interesting? Note the info on load rating for two pitch offset links versus one pitch offset.


https://tsubaki.eu/support/general-info/introduction-tsubaki-roller-chain/
Logged
BEIGE is all the rage

spooky

  • Full Member
  • ***
  • Posts: 1069
  • Sunny Dumfries
Re: chain question
« Reply #2 on: March 01, 2019, 05:09:50 PM »
Thanks for the link, i ended up getting a new chain, made life a lot easier,
Logged
Gn250,CG125, Terrot 125,st70

Propellor

  • Posts: 1187
Re: chain question
« Reply #3 on: March 01, 2019, 07:03:35 PM »
👍
Logged
BEIGE is all the rage

themoudie

  • Full Member
  • ***
  • Posts: 4755
Re: chain question
« Reply #4 on: March 01, 2019, 07:40:58 PM »
That would have been my choice Rufus.  ;)  A chain anklet is not what you are looking for!  ???

My regards, Bill
Logged
Pages: [1]
« previous next »