XBR Wiring/ petrol tank

[500 T C]

                   Does anyone out there, know where I can get a coloured wiring diagram from?Any input much appreciated.
      Petrol tank also has a few minor rust holes(leaking) any ideas?   

[themoudie]

Aye t.chainey,

I'm sorry, but I have no idea about the wiring diagram, an XBR loon maybe along soon!

However, sealant for a motorcycle tank providing the holes aren't 'HUGE', might I suggest the stuff from Frost's?

Link to Frost's sealant: FROST'S TANK SEALANT

I hope this helps.

My regards, Bill.

[SteveC#222]

I've only ever seen the B&W one in the workshop manual. If you need a copy PM me your email.

[500 T C]

Bill,
      with regards to the wiring diagram      .,many thanks.

[themoudie]

Aye t,chainey,

It's Steve#222 you need, I haven't anything XBR I'm afraid.

Also go canny about putting your email address up on the site, can be used I understand by scammers, but I'm not sure how.

If you hover the mouse over the two icons below our 'Avatars' on the left-hand side of the text box, you will see one icon for email and another for PM, that is what Steve was referring too.

Hope this helps.

My regards, Bill.

[SteveC#222]

Diagram sent, check your email. 

[Frog]

Hi

for petrol tank leaks I have had good success with plastic padding leak fix. As long as the deteriorated area is small it works very well (has lasted a couple of years so far). 

Knock any pinprick holes in with a ballpien hammer so they are below the surface, rough up the surface, make sure they are totally dry  then fill with the stuff, allow to set (its fast),  smooth off, paint and refill.

Cheers
Frog

[guest564]

I keep a set of coloured pencils for marking up wiring diagrams.