srx600 frame info

[reborntoride]

Hi all, Hope someone can help
I have recently acquired a srx rolling chassis but the bloke that had it before had put a
500 motor in it and had cut all the engine mounts. So my question is can anybody hep with a few
measurements on the engine mounts. Front / bottom mount distance either side to downtube and rear
bottom and top mount distance from frame. I live in Mt Gambier Sth Australia so there isnt many or any bikes
close by to have a look at. Be interested to hear from any Aussie's who use this site

[Ian]

Hi reborntoride, I have a spare (600) frame that has been cut down at the rear. I will try and take some measurements you require this week and send them on to you. I will send some photos too...perhaps that may help? Pity you arent in this country (uk) You could have this frame for nothing.
Regards

Ian

[reborntoride]

Thanks Ian   
 I will appreciate the photo's and measurements. Iam 95% sure its in the right position, but its that 5%
that causing the welding hand to shake.