Did the srx head to specified (18 lbft?/ 2.5 NM?? rings a bell...) torque sttings.
It doesn't seem that tight tho...
1. I dont want to overdo it (ally barrel)
2. I dont want it not to have enough!
It could definately take more... Even a wee extra nip...
After all bolts "clicked" the torque wrench, I went round an "clicked" them again, just to be sure. They all gave a little extra before clicking. Not a lot, but a bit.
Do I leave it be???
Only reason I'm asking is the norton settings are "as tight as you can get it", and there's been no bother there, but that is onto a cast iron barrel, with a big, coarse thread on the (big, course) bolts...
Leave alone now? Cheers! I promise this is the last posting on the topic!!!
a