Hello All,
Yet more issues with XBR rebuild!
I am about to fit the cylinder head again (3rd try) and find that the retainer is shown in the manual as a 5mm peg. I have several cylinder heads and have pegs for 2 of them but the head I want to use (all vapour blasted and valves ground in etc) has a larger 6mm hole for the retainer and the adjuster is threaded. I can't find any information about this and wonder if anyone can tell me what the retaining bolt(?) looks like. I have several boxes of engine bolts etc from the several engines I have and have hopefully added pictures of various items.
Any ideas?
I'll try and add some photos later.
Thanks very much,
Richard.
Added some pictures below:
picture of bolt I suspect is correct
pic of adjuster shaft showing thread
Pic of locating peg in correct head
pic of same peg in head I am using