Thumper Club Forum
Technical => Bike Problems/Questions => Topic started by: richardeblack on October 27, 2020, 12:29:47 PM
-
Does anyone know the size of the XBR flywheel puller. I think it is 22mm by 1.5 pitch but unfortunately my lathe is imperial for screw cutting so stuck with buying one (1.5 pitch is, as near as dammit, 17tpi and lathes only give 16 or 18!!). Please can anyone confirm that it is 22mm? When I run the part number in the manual, it comes back with 20mm by 1.5 which is too small.
Many thanks.
Richard.
-
Sorry All,
just done another search of the forum and it came up this time so looks definitely like 22 by 1.5 so will have to try and buy one or get one of the kits.
Thank you.
Richard.