Thumper Club Forum

Technical => Recommended Services => Topic started by: themoudie on January 06, 2017, 08:53:28 PM

Title: Steelcraft, Soham, fabrication and engine fettling
Post by: themoudie on January 06, 2017, 08:53:28 PM

Might I suggest an alternative to the lamented and late Denver M/c's in Norfolk? Whilst not specialising in Yamaha singles, they make Ducati 250's race reliable, beat 350 and 500 singles in the Classic and Vintage classes on them and Andy uses a RE Conny to good effect in the BHRC chair classes. They have an effective home made flow bench setup that produces the results. Stu Noble and Andy Hunt are the proprieters and if the place is shut they are probably off racing!  ;D

Link:Steelcraft_Soham (http://www.steelcraft.biz/)

My regards, Bill

Title: Re: Steelcraft, Soham, fabrication and engine fettling
Post by: Steve Lake on May 08, 2017, 08:31:43 PM

Note to self .... pull finger out and get down to see them  ... only 20 miles from workplace...
thanks Bill