Thumper Club Forum
Club House => Chatter => Topic started by: beeman on March 30, 2007, 10:12:18 PM
-
Just picked up an exhaust for an srx.
Down pipes are simular to originals, it then goes into a single 50mm pipe with springs to hold in place.
This pipe exits behind the footrest no end can insitu but has rubber 'O' ring to aid sealing when one is fitted.
Underneath the the engine is a separate pipe 50mm in diam about 20-25cm long sealed at both ends running parallel to the main pipe and connected to it by 2 short 20mm approx tubes. this is remeniscent to what micron were making 3-4 years ago. The idea being sound waves would take different times to get through the pipe so ? canceling each other out.
My question is who made this pipe does anyone know?
ps boyd couldn't call round yesterday as trailer lights were playing up and had to get home before dark.