Thumper Club Forum

Technical => Bike Problems/Questions => Topic started by: DIB on July 13, 2011, 09:07:51 PM

Title: HONDA CB250RS REAR WHEEL BUSHES
Post by: DIB on July 13, 2011, 09:07:51 PM

Does anyone know of a supply of the rear wheel bushes on my CB250RS or indeed if bushes from another model may fit?


Regards


Mark

Title: Re: HONDA CB250RS REAR WHEEL BUSHES
Post by: SteveC#222 on July 13, 2011, 10:23:21 PM

Bushes as in bearings?

Try Wemoto.com

http://www.wemoto.com/bikes/Honda/CB_250_RSA/81-84/ (http://www.wemoto.com/bikes/Honda/CB_250_RSA/81-84/)

Title: Re: HONDA CB250RS REAR WHEEL BUSHES
Post by: guest295 on July 14, 2011, 08:24:45 AM

They should be sealed ball bearings. Measure the spindle diameter and the bearing's outer diameter and go to your friendly neighbourhood bearing shop for a set.

Title: Re: HONDA CB250RS REAR WHEEL BUSHES
Post by: johnr on July 14, 2011, 06:53:51 PM

i think he means the round rubber bushes that they use as cush drives on the little honda.

Title: Re: HONDA CB250RS REAR WHEEL BUSHES
Post by: Dick Scratcher on July 14, 2011, 08:29:41 PM

No Idea Dib but if you do get any how the Hell are you going to get the old ones out ?, 'blind' holes +thirty years in position !. Any ideas, if so let me know, mine are getting sloppy.

Title: Re: HONDA CB250RS REAR WHEEL BUSHES
Post by: DIB on July 15, 2011, 04:53:53 PM

Yes it is the rear rubber bushes that the sprocket bolts go into too, should have been more clear; must have been the cider!

If I can get some I will get them out no probs! & let you know.


regards


Mark