Thumper Club Forum

Technical => Bike Problems/Questions => Topic started by: chippit on October 17, 2008, 06:37:42 PM

Title: SRX400 carbs
Post by: chippit on October 17, 2008, 06:37:42 PM

Hi,
Just read the thread on srx600 carbs, I have also been trying to get a choke plunger, the one I have bought (great expence ) has the pin in the end where as the original is flat, I couldn't get the new one to fit.The new part was obtained with the frame no. so I'm not sure what part I need. The plunger has an 'o' ring half way up. Has any one got any ideas?

I have also been trying to find a 44 pilot jet as these are no longer available (apparently.) With a 46 in it makes no difference turning it  right in to tune it, am I right in thinking that this should stall it.

Regards Chippit.

Title: Re: SRX400 carbs
Post by: Steve Lake on October 21, 2008, 07:11:46 PM

erm....i have a pile of old srx carbs in various states if disrepair....i'll check them out and see what i've got in the way of serviceable choke assemblies.....don't hold your bref