Thumper Club Forum
Technical => Project Progress => Topic started by: guest27 on November 15, 2007, 10:58:43 PM
-
Looooooong time back I was told by anumber of you not to bother with an AMal carb for the Rotax lump but to find a Mikuni carb. Well allowing for the vageries of the PO there will be a nice big one arriving from fleabay soon. Now having told me I need an Mikuni on it - does anyone have any starting points for jetting it? With the Amal I was going to jet the 40 the same as the 32 and go from there - main would need to be biger but the pilot etc may have been right. So anyone of you have any jetting specs for a Mik on a Rotax?
Ta
R
-
Try Allens Performance...the Mikuni Specialist.
Jethro
-
Ta Jethro - I always feel bad about asking advise as I may end up buying nothing - mind I habd out advise to prostective customers like sweeties outside a sixthform college...
Carb has arrived - bugger it is big, and rather lovely - Glad I did not get the hole in the bottom of the tank welded I will have to make it bigger.
R
-
Rog if its a VM44...you really DONT want it honestly!........BUT it would be fine on my bike ;D
-
LOLOLOL Mik - It is apparently an OE carb from something. It would bore out to 44 and is probably far bigger than my nike needs - what is it on yours a 40? 38 mm dellorto?
Oh if you still have them I am still interested in those wheels - just not seeming to get far from home with out a really tight leash at the mo.
R
-
yeh supppose i will just have to stick to my poxy 40mm dellorto then :'(
Still got the wheels, not bothered advertising them so still yours. ;)
-
Ahhhh sad
If you want to have a nose at the mikki I can always take a load of pics and send them to you.
R